cougarguard.com — unofficial BYU Cougars / LDS sports, football, basketball forum and message board - View Single Post

Clark Addison · 07-26-2008, 08:26 PM

Any electricians on board? I am a self-taught handyman, and have never dabbled in anything electric for fear of killing myself.

I am putting in a new, replacement, garage door opener. There are currently wires that go from the control panel, into the wall, up, and come out of the ceiling above the motor unit. I would like to just re-use these wires, since I don't know how I would get wires through the wall, and it would look better than stapled wires up the wall.

The problem is that the old wires are 24 gauge. The wires that came with the new unit are 22 gauge. So would it be a bad thing to use these wires?

07-26-2008, 08:26 PM	#1
Clark Addison Senior Member Join Date: Jul 2007 Location: North Carolina Posts: 638	Wire Gauge Question Any electricians on board? I am a self-taught handyman, and have never dabbled in anything electric for fear of killing myself. I am putting in a new, replacement, garage door opener. There are currently wires that go from the control panel, into the wall, up, and come out of the ceiling above the motor unit. I would like to just re-use these wires, since I don't know how I would get wires through the wall, and it would look better than stapled wires up the wall. The problem is that the old wires are 24 gauge. The wires that came with the new unit are 22 gauge. So would it be a bad thing to use these wires?